Σήμερα κατέβασα το εγχειρίδιο λειτουργίας του. Σου παραθέτω τα εξής:
7.3 Pressure switch
The compressor has a pressure switch which cuts
out when the set pressure has been reached.
The cut-out pressure is set at the factory to approx.
4 bar with the pressure regulator fully opened
(

. As compressed air is used, the compressor
will cut in again after the pressure falls below
a lower limit set at the factory.
Aρα έχει ενσωματωμένο autostart/autostop

7.2 Pressure setting (Fig. 1, 5)

Do not use pressure settings of less than 1
bar. If the output pressure is set to below 1
bar, the compressor will not start because of
pressure differences set at the factory.
Αυτή η παρατήρηση συνεπάγεται οτι θα δυσκολεύεσαι να πετύχεις πολύ λεπτές γραμμές. Αντιμετωπίζεται με προσθήκη δεξαμενής στην έξοδο του συμπιεστή
Α και παραγόμενος θόρυβος είναι

60 dcb