Αν βοηθάει καθόλου αυτό:
The leFH18 Howitzer:
TrumpeterThis is quite a nicely detailed gun with plastic barrel split vertically and a separate four part breech and breech block that allows it to be positioned open or closed and a large double baffle muzzle brake in two parts. The breakdown of the gun parts has the cradle in two halves with nice bolt head details and left and right lower cradle with the two supports for the upper recuperator as well as the hand wheels and well detailed gun sight.
The side mounted recoil cylinder is moulded in one part with a separate lower piston that fits into the hole already in the cylinder and will move freely after assembly so the gun can elevate as required. There are a couple of pin marks on the recoil cylinder and one on the upper recuperator that will need eliminating but other than that there were no other cleanup issues.
Assembly was straightforward without any problems on the gun itself but there were a couple of issues with the new front shield, armoured carriage and recuperator housing.
The front part of the carriage is armoured and is moulded separate from the rear carriage designed to fit to the front of the central gun shield (part G45), this is moulded rather thick and has some pin marks on the back to be removed. The upper recuperator housing (part G41) doesn''t fit into the recess in part G45 and it is easiest to just position this so it lines up with the lower carriage rather than try and enlarge the recess, which is only going to arrive at the same result anyway. Also note the two small fittings (parts G29, G30) on either side of the part G41 are numbered incorrectly in the instructions and part G29 should be G30 with part conversely G30 should be G29.
The locating hole in the top rear of the shield for the recuperator cylinder had to be drilled out as it was too small for the cylinder and the shield and front part of the carriage (part D) is then attached to the main gun assembly and barrel ensuring everything lines up correctly. The muzzle brake can now be attached to the barrel but don''t fit this earlier or you will never fit the barrel through the gun shield.
The front lower shield (part F27) is actually attached centrally to the lower carriage assembly and not to the barrel as shown in the instructions with the fitting of this part being very vague in the instructions and care should be taken with this.
The lower gun mount is straight forward and this is attached to the hull interior side sponsons later and can be left separate from the gun at this stage.
http://www.perthmilitarymodelling.com/reviews/vehicles/trumpeter/tr00353.htmΕλπίζω οι παρακάτω φωτογραφίες να σε βοηθήσουν
Αυτές είναι από το ίδιο κιτ με το δικό σου:
